All You Need to Know About the Best Decorative Concrete
Stamped concrete can be a beautiful addition to any property. However, this needs to be given utmost attention and care because if you do it badly, your property will look unsightly. Until the slab has been washed and waiting for sealing, this is when most of the contractors notice the problems and this is why you need to make sure that you do not miss any spots during the process. This is why you need a contractor that has experience because they have probably been in these scenarios and they know how to prevent them. We have listed below some of the tricks you could use to make sure that you achieve the best textures. First, you need to stamp early. You do not need a tamper as you will need to just walk on the stamps into the surface if you start stamping early.
The other thing you could do is reduce the evaporation by setting the retarders. The top surface might have crusted over and you can be fooled that the slab is already hard enough for stamping. The crust will start cracking as soon as you start stamping and you find yourself sinking. There is need to apply the evaporation retarder so that the top dries well. Retarders usually slow down the evaporation process so that you the slab is properly textured.
The next thing you need to do is make sure that the slab is crawled. Get kneeboards and send the people out before you go ahead with the stamping. The weight and the vigorous floating of the slab will work the surface up. You will get the same consistency throughout the slab and this will enable stamping be easier. You will easily get the results you want this way. In the case you have the slab getting ahead, all you need to do is use a roller on the surface. Getting texture is easier this way.
Stamping the slab could be done using shoes that are textured as one of the best ways. The stamping shoes are not designed with any straps or buckles and they are held into place with friction. You will easily walk over the concrete without sinking since the weight of the wearer spreads over a large area. Starting in the middle moving out is the best way to approach the stamping situation. Stamping will be more uniform this way and you will not have the problem of different textures on opposite ends of the slab. However, you will need to have more stamps than normal if you go with this approach but you will have consistent texture throughout.